S
U
A
1800 909 909
www.globalpowerbrands.com email: [email protected]
AFTER SALES SUPPORT
36357
S
U
A
1800 909 909
www.globalpowerbrands.com email: [email protected]
AFTER SALES SUPPORT
36357
11
Unpacking
Due to modern mass production techniques, it is unlikely that your power tool
is faulty or that a part is missing. If you find anything wrong, do not operate the
tool until the parts have been replaced or the fault has been rectified. Failure to
do so could result in serious personal injury.
Adjusting the handle
To adjust the handle to the desired
operating angle, press the button at the
rear top of the vacuum/blower unit, pull
the upper handle arm upwards until it is
fixed up and secured.
Attaching the collecting bag
1. Insert the lower two feet of the bags
frame into the supports at the rear end
of the chassis.
2. Line the clip that is below the collection
bag handle into place at the entry point
(11) this is located below the collection
bag release button (10).
Before starting
1. Make sure that the handle is properly secured in the correct
operating position.
2. Always make sure that the collecting bag is attached to the
wheeled vacuum/ blower unit before you switch on the device
(both in vacuum and blower mode).
3. Your wheeled vacuum/blower is controlled by trigger switch
on the handle.
4. Connect the unit to an extension cable. Feed the extension
cable through the handle and around the strain relief (12).
5. Always direct the cable backwards away from the device.
Note.
If the cable should be damaged during operation,
switch the machine off and disconnect the mains cable from
the mains supply. Do not touch the cable before you switch off the mains supply.
Getting Started
4
Summary of Contents for 36357
Page 16: ... ...
