Phone Orders: 1-800-427-3363 • Customer Service: 1-800-876-5520
e-mail: [email protected] • Web: www.gardeners.com
Ball Chain Assembly
Step 1.
Attach a Chain Connector to each Large Split Ring (Figure 6). If
necessary, use needle-nose pliers to pry and hold open the Split Rings.
Step 2.
Connect one end of each Ball Chain to a Chain Connector on
the Large Split Rings. The last ball of each chain will “snap” onto the
connector (Figure 6).
Step 3.
Take the loose end of one Ball Chain and thread it through the Chain
Grip (Figure 6 detail) then through the Guide Hole in the side and near
the top of the S2 Bar (Figure 7). Direct the loose end of the chain over the
spacer inside the A3 Bar (Figure 7). If this proves difficult, attach a twist-tie
to the end of the chain to help lead the chain over the Spacer. Repeat this
step to install the Ball Chains on both sides and at each tier of the Frame.
Step 4.
Attach a Chain Connector and Small Split Ring to the end of each Ball
Chain (Figure 7). Repeat this step for all Light Fixtures.
Step 5.
Find the two slots with the “T”-shaped tabs in the top of each Light
Fixture. Hook each hanging Small Split Ring around the “T”-shaped tabs
(Figure 8).
Tip
: Angle the ring around one side of the T, then the other.
Adjusting the Fixtures
Step 1.
Check the Ball Chains to make sure they are correctly positioned and
move freely through the Chain Grips when pinched.
Important:
Support
the Light Fixture with one hand when pinching the Chain Grips.
Step 2.
Adjust the height of the Light Fixture one side at a time by pulling the
chain out of the Chain Grip with the least amount of resistance, as shown
in Figure 9.
Important:
While supporting the Fixture with one hand,
be sure the Chain Grip firmly catches the chain before removing your
support.
Fixture Use and Safety
•
Use the power cord only with a properly grounded electrical outlet or
power strip. If water is spilled near the power source, unplug the unit
before you wipe up the water.
•
Do not put objects on top of the Frame or on Light Fixture.
•
Always turn off the power to the Light Fixtures when inserting,
adjusting or removing Light Tubes. If you insert a Light Tube when
the power is on, it may trigger an auto safety mechanism, resulting in
the light shutting off. If this happens, turn off the Fixture; make sure
the Light Tubes are fully seated in the tube sockets; wait for thirty
(30) seconds, then turn the Fixture on again. This will reset the Light
Fixture so the lights operate normally.
•
For best results, attach a timer to your lights to control the length of
time the lights are on and to be sure your plants get adequate light.
Clean the fluorescent tubes monthly with a soft dry cloth
to ensure maximum light output.
T-5 Fluorescent Bulbs contain Mercury and must be disposed
in accordance with Disposal Laws. See www.lamprecycle.org or
call 1-800-427-3363 for disposal information.
The light intensity of fluorescent bulbs diminishes over time.
When it’s time to replace your bulbs, please dispose of them
safely at your recycling center.
For products, articles and tips on seed starting and growing
under lights, please visit us at www.gardeners.com.
S2 Vertical
Bar
Pull chain out in a horizontal
direction.
Figure 9
Guide Hole
Chain Grip
Figure 6
Large Split
Ring
Chain
Connector
Chain Grip
Ball Chain
Figure 7
A3 horizontal
bar
Spacer
Guide
Hole
S2
vertical
bar
Ball Chain
Chain
Connector
Small Split
Ring
Figure 8
T-tab on top
of Fixture
