LIT SKU: 8595753 0967G Rev 04/17
#8593942
Coltura LED Grow Frame
This innovative Coltura LED Grow Frame is a sleek, space-saving way to grow thriving plants. Mount it on a wall or place it on a
tabletop. You can grow herbs in the kitchen, orchids in the living room, or use it to start seeds for your garden. The light panel easily
adjusts to any height with the magnet system.
WARNING:
The Coltura LED Grow Frame includes small, strong magnets. Keep it out of the reach of small children.
Parts List
(1) Assembled Grow Frame with attached Power Cord
(1) unattached Power Cord
(1) Hanging Clip
(1) Spacer
(2) Screws
(2) Plastic Anchors
If you are mounting your Grow Frame on a wall, follow the Hanging Instructions below.
Otherwise you can skip to Step 5.
Hanging Instructions
Important:
The included hanging hardware (Screws, Plastic Anchors) is to be used when
hanging your Grow Frame on drywall. If you are hanging it on a different type of wall, such as
brick or wood, check with your local hardware store to find the correct type of hardware you
will need.
Step 1.
Choose a location to hang the Grow Frame and use a pencil to lightly mark the wall
where the top center of the Frame will sit.
NOTE:
This is where the Hanging Clip will be
installed.
Step 2.
Place the Hanging Clip in the marked location, making sure it is straight and oriented as
shown in Figure 1. Mark the wall where each of the holes in the Hanging Clip are. Remove
the Hanging Clip and place it to the side. At each mark, drill a hole in the wall
that is the same size as the Plastic Anchors. Push an Anchor into each hole.
Step 3.
Position the Spacer behind the Hanging Clip and place them against the
wall, lining up the holes with the Plastic Anchors. Place a Screw through each
set of holes, into the Plastic Anchors.
Step 4.
Slide the top of the Frame onto the top of the Hanging Clip and rock it
back to secure it to the bottom of the Clip (Figure 2).
Important:
Make sure the
Frame is securely attached to the Hanging Clip before continuing.
Set Up Instructions
Step 5.
Slide the transformer on the attached Power Cord through the back of the Frame. Plug the
unattached Power Cord into the transformer.
Step 6.
Tuck the Power Cord behind the raised edge of the Frame Clip closest to it (Figure 3).
over please
Figure 1
Hanging Clip
top
bottom
Hanging Clip (side view)
Frame (side cut out view)
Figure 2
Spacer
Frame
Clip
Power
Cord
Hood and
Light Panel
Figure 3
