3.10.11.1 To set the corridor width of the guide
wire
1. Do steps 1–3 in
on page 23.
2. Use the arrow buttons and the OK button to
move through the menu structure
Installation
> Advanced > Corridor width > Guide.
3. Use the number buttons to select a corridor
width of 0–9.
4. Push the BACK button.
Note: Make the corridor width as wide as
possible for a minimum risk of lines in the lawn.
3.10.12 ECO mode
If
ECO mode is activated, it switches off the
signal in the boundary loop, the guide wire and
the charging station, when the product is parked
or is charging.
Note: Use
ECO mode to save energy and avoid
interference with other equipment, for example
hearing loops or garage doors.
Note: To start the product manually in the work
area, push the STOP button before you remove
the product from the charging station. If not, the
product can not be started in the work area.
3.10.12.1 To set the ECO mode
1. Do steps 1–3 in
on page 23.
2. Use the arrow buttons and the OK button to
move through the menu structure
Settings >
ECO mode.
3. Push the OK button to select the
ECO
mode.
4. Push the BACK button.
3.10.13 General
In
General you can change the general settings
of the product.
3.10.13.1 To set the time & date
1. Do steps 1–3 in
on page 23.
2. Use the arrow buttons and the OK button to
move through the menu structure
Settings >
General > Time & Date.
3. Use the number buttons to set the time and
then push the BACK button.
4. Use the number buttons to set the date and
then push the BACK button.
5. Use the arrow buttons to set the time format
and then push the BACK button.
6. Use the arrow buttons to set the date format
and then push the BACK button.
3.10.13.2 To set the language
1. Do steps 1–3 in
on page 23.
2. Use the arrow buttons and the OK button to
move through the menu structure
Settings >
General > Language.
3. Use the arrow buttons to select language
and then push the BACK button.
3.10.13.3 To set the country
1. Do steps 1–3 in
on page 23.
2. Use the arrow buttons and the OK button to
move through the menu structure
Settings >
General > Country.
3. Use the arrow buttons to select country and
then push the BACK button.
3.10.13.4 To reset all user settings
1. Do steps 1–3 in
on page 23.
2. Use the arrow buttons and the OK button to
move through the menu structure
Settings >
General > Reset all user settings.
3. Use the right arrow button to select
Proceed
with reset of all user settings?
4. Push the OK button to reset all the user
settings.
Note:
Security level, PIN code, Loop signal,
Messages, Date & Time, Language and Country
settings are not reset.
3.10.13.5 The About menu
The
About menu displays information about the
product, for example serial number and firmware
versions.
28 - Installation
1378 - 003 - 16.04.2020
