11
GB
The additional filter can be installed as a pond edge controller for
adjusting water features and cleaning the filter housing from the
edge of the pond. Water is only drawn in via the additional filter.
You can connect the following hoses to the hose connection :
.
3 /4
”
and 1
”
for FP 750 E / FP 1000 E / FP 1400 E / FP 1800 E /
FP 2500 E
.
1 1/4
”
and 1 1/2
”
for FP 4000 E / FP 5000 E / FP 7500 E
For best results use a hose with the largest possible diameter.
1. Remove the cap
3
from the pump.
2. Press in snap fastenings
6
and
open up the filter housing
5
.
3. Push the hose connection
7
on to the pump.
4. Close filter housing
5
.
5. Insert hose connection
8
in
to one filter shell
4
and snap
into the second filter shell
4
.
6. Press sealing cover
3
on to
the pond edge control
4
.
7. Connect water feature pump
and pond edge control to a
hose.
4. Initial Operation
1. Place water feature pump on a firm base in such a way that the
filter housing
5
is completely covered by water.
2. Pull telescopic pipe
9
out to the desired length.
3. Netzstecker in eine Wechselstromsteckdose einstecken.
Warning: Pump will start immediately.
4. Set the quantity of water required for the water feature using the
regulator
0
.
5.
Water bell :
Screw insert into the water feature until the water
feature has produced the shape required.
TIP :
Install the pond edge controller on a bed of gravel to
improve the water intake. The regulating valve
0
must be fully
open when using the pond edge controller.
1. Fill hose with water to remove any cushions of air in the hose.
2. Secure the pond edge controller at the edge of the pond (using
rocks, for example).
The pond edge control must be completely covered with water.
3. Set the quantity of water required for the water feature with the
regulator
A
.
Switch on water
feature pump :
Start pond edge control :
VARIANT 2 : Mount the pond
edge controller :
0
A
9
5
0
9
5
4
3
8
7
7
3
5
6
