Gardena 46 V, User Manual

Page: 13 / 13

26
GB
27
GB
Only original GARDENA Blade Bars with original fixing must
be used. Spare GARDENA parts can be obtained from your
GARDENA dealer or the GARDENA service department.
• 46 V / 46 VD / 46 VDA: GARDENA Blade Bar
Art. 531211017
• 51 VDA: GARDENA Blade Bar
Art. 504113301
Fault Possible cause Remedy
Engine does not start. Petrol tank empty.
v
Fill with petrol.
Wrong engine setting.
v
See 5. Operation “Starting the
mower with a warm engine” .
Spark plug connector not
inserted / spark plug faulty.
v
Insert spark plug connector/
clean or replace spark plug
(Champion RJ 19 LM
Art. 4012-00.901.01).
Cutting height too low for the
lawn or mowing speed too high.
v
Raise cutting height or
reduce mowing speed.
Motor does not start. Bowden cable of the switch
handle has moved due to wear.
v
Adjust Bowden cable of the
switch handle.
After an initial warm-up
phase, the motor starts only
with difficulty or not at all. Too much oil in the motor,
spark plug is coked
by excessive oil quantity.
v
Release excessive oil
following the instructions
for the motor and clean
the spark plug.
Drive does not start. Bowden cable of the drive has
moved due to wear.
v
Adjust Bowden cable of the
drive.
Engine runs for a short time
but then suddenly stops with
a loud bang. No motor oil in crankcase.
Piston and crankshaft bearings
have jammed.
v
Have the engine serviced
by GARDENA Service.
A lot of engine smoke after
starting. Oil in the exhaust because
the mowr has been tipped
sideways.
v
Let the engine run for
about 3 min. until the oil
has evaporated.
Loud noises, mower rattling. Screws on motor, its fixing or on
the mower casing loose.
v
Have screws tightened by an
authorised specialist dealer
or GARDENA Service.
Runs unevenly,
mower vibrates strongly. Blade Bar damage or blade
fixing on the engine shaft has
come loose.
v
Have the blade bar
tightened again or replaced
by an authorised dealer
or GARDENA Service.
Imbalance resulting from very
dirty blade bar.
v
Clean mower
(see 7. Maintenance).
If this does not rectify the
fault, contact GARDENA
Service.
Fault Possible cause Remedy
Lawn is not cleanly cut. Blade bar blunt.
v
Have the blade bar replaced.
Cutting height too low for the
lawn or mowing speed too high.
v
Raise cutting height or
reduce mowing speed.
For any other malfunctions please contact the GARDENA service department.
Repairs must only be carried out by GARDENA service departments or specialist
dealers authorised by GARDENA.
9. Technical Data
46 V 46 VD 46 VDA 51 VDA
(Art. 4044) (Art. 4046) (Art. 4047) (Art. 4051)
Engine (cubic capacity) Briggs & Stratton Briggs & Stratton Briggs & Stratton Briggs & Stratton
450 550 675 ready start 675 ready start
(148 cm
3
) (158 cm
3
) (190 cm
3
) (190 cm
3
)
Wheel drive – 1 gear rear wheel variable rear wheel variable rear wheel
Engine oil (tank volume) SAE 30 (0,6 l) SAE 30 (0,6 l) SAE 30 (0,6 l) SAE 30 (0,6 l)
Petrol unleaded petrol unleaded petrol unleaded petrol unleaded petrol
(min. 87 octane) (min. 87 octane) (min. 87 octane) (min. 87 octane)
Cutting width 46 cm 46 cm 46 cm 51 cm
Cutting height
30 / 40 / 50 / 30 / 40 / 50 / 25 / 35 / 45 / 25 / 35 / 45 / 65 /
60 / 70 / 80 mm 60 / 70 / 80 mm 65 / 75 / 95 mm 75 / 95 mm
Height adjustment
central 6 x central 6 x central 6 x central 6 x
Wheel sizes 190 / 210 mm 190 / 210 mm 190 / 280 mm 190 / 280 mm
Wheel bearing ball bearing ball bearing ball bearing ball bearing
Mulch function incl. unit incl. unit incl. unit incl. unit
Collection Bag volume 53 l 53 l 53 l 60 l
Weight 29,9 kg 32,1 kg 34,3 kg 37,5 kg
For lawn areas up to approx. 500 m
2
up to approx. 800 m
2
up to approx. 800 m
2
up to approx. 1000 m
2
Water connection (cleaning) Original GARDENA hose connection system
Working area related emission
characteristic value L
PA
1)
84 dB (A) 84 dB (A) 84 dB (A) 84 dB (A)
Noise level L
WA
2)
measured 95 dB (A) measured 95 dB (A) measured 95 dB (A) measured 97 dB (A)
measured / guaranteed guaranteed 96 dB (A) guaranteed 96 dB (A) guaranteed 96 dB (A) guaranteed 98 dB (A)
Vibrations a
vhw
1)
< 5,0 m/s
2
< 5,0 m/s
2
< 5,0 m/s
2
< 5,0 m/s
2
Measuring method
1)
EN 836
2)
2000/14/EG