OPERATING YOUR CULTIVATOR
NORMAL OPERATION
•
The clutch will transfer maximum power to the unit’s tines after approximately 2 hours of
normal operation. During this break-in period, clutch slippage may occur. The unit’s clutch
should be kept free of all oil and other moisture to ensure efficientoperation.
•
When cultivating, do not place excessive body weight on the unit. The unit will operate most
efficiently with the use of its own weight.
STARTING AND STOPPING THE ENGINE
•
To prevent carbon monoxide poisoning (also see engine safety precautions) always move the
unit outdoors to a well-ventilated area before starting.
•
Always be aware of gas vapors and exhaust fumes. Before starting the engine, make sure it is
away from open flames or sparks.
•
Make sure the air filter holes and the fuel tank area are free of debris.
MANUAL START INSTRUCTIONS
WARNING
CAUTION
Always make sure the
When starting the unit, the starter rope can
unit is in a stabile
sometimes cause an unanticipated jerk back
position before pulling
towards the engine. Follow the instructions
the starter handle.
carefully to avoid any injuries.
Once the unit starts to
Always turn off the engine after every use.
engage, momentarily
Never leave it running unattended.
release the throttle
Never carry or move from the location while the
control with your right
engine is running.
hand. Move both hands Always follow the gas and oil instructions.
to the handlebar
Wear approved hearing protection.
position and use the
Do not attempt to start when there is fuel
handlebar to maintain
spillage present. Always clean up any spillage.
control and stability of
the unit.
MANUAL START / COLD ENGINE
Starting the engine for the first time or after running out of fuel or if the engine has cooled off:
1. Move choke lever to the RUN position.
a. NOTE: Choke must be in the RUN position when engaging the primerbulb.
2. Use the primer bulb to prime the unit until the primer hose and bulb are full of gasmixture.
a. NOTE: When using the primer bulb, allow the primer bulb to completely return to its
original position after each pump.
3. Move choke lever to CHOKE position
a. NOTE: In the CHOKE position, always move the lever to the farthest CHOKE position
possible.
4. Push the rocker switch to the ON position.
11
Mini Cultivator
Model GTW33
Summary of Contents for GTW33
Page 23: ...23 Mini Cultivator Model GTW33...
