Fig 1
Fig 2
Fig 3
Fig 5
Step3:
1.
Insert the bo
tt
om rib (the one without wheel) of the Canopy (G) into the b
ott
om of Beam with
Screw Holder (B), as shown in Fig.1
Connect the top rib of the Canopy (G) onto the top of Beam with Screw Holder (B) with M5x15
Screw and Nut (X), as shown in Fig.2
2.
Place the ribs with wheels onto the Cambered Rail (C), as Shown in Fig.3 & Fig.4. (Make sure all
the wheels are on the back side of the magne
ti
c plate (Z5).
3.
Thread
the wire of the Canopy (G) through the top of the Beam Hub (K). As shown in Fig.5.
Secure the Canopy (G) and Beam Hub (K) with a Nut and Washer (U), using Nut Wrench (Z) on the top of
the Beam Hub (K) and Wrench (Z12) under the Canopy (G). Tighten them as shown in Fig.6
Step 3
K
G
G
B
G
G
X
B
Fig 4
C
Fig 6
K
U
G
4
Z
12
Z
5
