Product ID 820.2170 / Instruction ID 445.35.30
Updated 11/19/19
Bowers Forest Products / PO Box 589 / Beavercreek, OR 97004 / Cust. Serv. 503-631-4408
HERITAGE PERGOLA ARBOR
ASSEMBLY INSTRUCTIONS
GARDEN STRUCTURES
STEP 1
•
Lay one of the side panels flat on your work surface,
aligning one brace to the pencil mark on the post.
•
Using one 2½ screw, secure the brace into the side panel,
flush with outer edge of post. Refer to Step 3 to square up
the arbor.
•
Attach a second brace to the opposite post of the same
side panel, aligning the brace to the pencil mark, flush
with outer edge of post.
•
Repeat the above processes to attach the remaining two
braces to the other side panel.
STEP 2
Pencil mark
NOTE: Staples on the side
panel lattice should face
the outside of the arbor.
•
Lay one of the 2” x 6” headers flat on your work
surface, aligning a side panel to the pencil mark on
the header. Header will be about 1” above top of
post.
•
Using one 1¼” screw, secure the side panel to the
header in the higher of the two pre-drilled holes.
The other screw will come later.
•
Attach the second side panel to the opposite end of
the header, aligning the panel to the pencil mark.
•
Turn the assembly over and attach the second
header following the same method as the first.
.
.
Pre-drilled holes
