Gardebruk Debua ASX900, Instructions Manual

Page: 33 / 78

www.DeubaXXL.de
33
footing and balance at all times.
Preparation for cutting
Wear non-slip gloves for maximum grip and protection. Maintain a proper grip on the
unit whenever the motor is running. Use your right hand to firmly grip the rear handle
while your left hand has a firm grip on the pole shaft.
Never use a left-handed grip, or any stance that places your body or arm across the
chain line. Never stand directly under the limb you are cutting. Be certain the collars
are fully tightened before operating equipment; check them periodically for tightness
during use to avoid serious injury.
Limbing and pruning
This unit is designed for trimming small branches and limbs. For best results, observe
the following precautions. Plan the cut carefully. Be aware of the direction in which the
branch will fall. Branches may fall in unexpected directions. Do not stand directly under
the branch being cut. The most typical cutting application is to position the unit at an
angle of 60° or less, depending on the specific situation.
As the angle of the pole chain saw shaft to ground increases, the difficulty of making
the first cut (from the underside of limb) increases. Remove long branches in several
stages. Cut lower branches first to allow the top branches more room to fall. Work
slowly, keeping both hands on the saw with a firm grip. Maintain secure footing and
balance. Keep the tree between you and the chain while limbing. Cut from side of tree
opposite branch you are cutting. Do not cut from a ladder; this is extremely dangerous.
Leave this operation for professionals. Do not make the flush cut next to the main limb
or trunk until you have cut off the limb further out to reduce the weight. Following
proper cutting procedures will prevent stripping the bark from the main member. Do
not use the pole chain saw for felling or bucking. To prevent electrocution, do not
operate within 15m of overhead electrical lines. Keep bystanders at least 15m away.
60°