GT8503E SECURITY FLOODLIGHT
–
SOLAR POWERED
ONCE YOU HAVE THE SETTINGS WORK UNDER THE CONDITIONS YOU PREFER, TEST THE COVERAGE AREA
OF THE SENSOR BY WALKING AROUND (AT THE LUX SETTING YOU HAVE SET.). YOU CAN ADJUST THE ANGLE
OF THE MOTION SENSOR PIVOT ANGLE AND THE
“
SENSITIVITY
”
SETTING
”
TO OBTAIN DIFFERENT COVERAGE
AREAS.
MAINTENANCE
1. KEEP THE SOLAR PANEL AND LIGHT LENS CLEAN. WIPE WITH A CLOTH AND / OR WITH SOAPY WATER.
2. IF YOU STORE THE UNIT INSIDE FOR MORE THAN 2-3 DAYS, TURN THE SWITCH FROM
“
AUTO
”
TO
“
OFF
”
.
RECHARGE THE BATTERY AS DESCRIBED IN STEP #2, WHEN PUT BACK IN SERVICE IF STORED FOR
ANY EXTENDED LENGTH OF TIME.
3. THE BULB IS A STANDARD, TWO PRONG, 10 WATT, 6 VOLT, HALOGEN BULB. USE A FLAT BLADED
SCREW DRIVER TO POP OFF THE LENS AND REPLACE AS NEEDED. DO NOT TOUCH THE BULB WITH
YOUR BARE FINGERS. THEY HAVE OIL ON THEM AND THIS OIL CAN CAUSE THE BULB TO BURN OUT.
4. WITH NORMAL USE, THE BATTERY WILL NEED REPLACEMENT AFTER 3 YEARS. A STANDARD 6V, 4Ah,
LEAD ACID RECHARGEABLE BATTERY IS USED. REMOVE THE 4 HOUSING SCREWS ON THE BACK OF
THE UNIT TO ACCESS THE BATTERY FOR REPLACEMENT.
PG 4 QUESTIONS ???? CALL 1-866 664 2724 REV 2, 12/11
