FRONT
OF CABINET
STEP 2B
D
F
A
DETAIL A
STEP 2C
F
D
35 1/4"
F
1/2"
STEP 2 AND 3
ARE CRITICAL TO HAVING THE CABINET HANG ON THE TEKPANEL WALL WITH HEAVY LOADS.
PVC
1/2" PIPE
SCHEDULE 40
X4
STEP 2A
2. ASSEMBLE POSTS:
A. LOCALLY PURCHASED 10FT LENGTHS OF PVC 1/2" PIPE, SCHEDULE 40. CUT INTO LENGTHS OF 35 1/4" TO MAKE
THE POST (F). X4
B. THE POSTS (F) TO BE INSTALLED IN THE FOUR LOCATIONS SHOWN.
C. SLIDE EACH POSTFROM THE TOP HOLES THROUGH THE CABINET PAST THE BOTTOM HOLES.
LOCATE THE POST INSIDE THE HOLE OF EACH BOTTOM CAP (D) AND PUSH THE CAP (D) UP INTO THE BOTTOM
HOLE OF THE CABINET. AT THE TOP, LOCATE EACH POST TO THE INSIDE THE HOLE OF EACH TOP CAP (D) AND
PUSH THE CAP (D) INTO THE TOP CABINET HOLE.
3. SECURE POSTS AND INSTALL BRACKET
A. WITH THE CABINET ON A SOLID SURFACE, PRESS DOWN ON THE CABINET TOP AND DRIVE SCREW (O) X6 INTO THE
POSITIONS SHOWN. (PRESS ING DOWN ON THE CABINET TOP TAKES OUT THE CLEARANCE FROM "LOOSE" ASSEMBLY
FITS AND INSURES THE DOORS SHUT PROPERLY WHEN HANGING ON THE TekPanel WALL.)
B. LOCATE THE PANEL BRACKET (N) ON THE BACK OF THE CABINET AND SECURE IN PLACE WITH X8 TekPanel SCREWS
1 5/8"LONG. THE BRACKET HAS SELF LOCATING TABS FOR THE TOP , BUT BE SURE TO CENTER HORIZONTALLY ON THE
PREVIOUSLY INSTALLED POSTS (F). AGAIN, PRESS DOWN ON THE CABINET TOP TO TAKE OUT THE CLEARANCE WHEN
DRIVING THE SCREWS. REPEAT OF THE OTHER SIDE.
PAGE 3 OF 4 REV AUG 2021
