QCXSUN
2. PROGRAMMING QCXSUN
1
2
3
1
Press and hold PROG-TX button of the MASTER
transmitter till the motor starts moving
2
Check the motor rotation then release Prog-TX
button
3
Press 1+2 (if motor move UP) or 2+3 (if motor move
DOWN) button of the QCXSUN
Transmitter is now programmed
3. SUN SENSIBILITY THRESHOLD ADJUSTMENT
1. Press and hold BUTTON 3 (the LED will turn on at first) until the LED starts to flash slowly,
release BUTTON 3
2. Adjust the threshold by using BUTTONS 1 and 3 which will allow you to either increase
(Button 1) or decrease (Button 3) the threshold.
Whenever a button is pressed the LED flashes according to the level of sun threshold (1,
2 or 3).
Threshold 1 - 5 Klux (default) = Low light (most sensitive) > led flashes 1 time
Threshold 2 - 30 Klux
= Med Light > led flashes 2 time
Threshold 3 - 60 Klux
= High light (less sensitive) > led flashes 3 time
3. Once the desired threshold has been obtained press BUTTON 2 to confirm.
NOTE:
It is important to program the sun sensor’s threshold within 30 seconds or the time
out function will automatically exit the programming procedure without saving the new
threshold.
Led
flashes
slowly
Press 1
to increase
the threshold
Press 3
to decrease
the threshold
Press 2
to confirm
threshold
1
2
3
IMPORTANT: QCXSUN sensor can only be programmed once the radio motor has already been
programmed to a transmitter.
