126
127
GAP Diagnostic 2019-07-15 All Rights Reserved
User Manual : Version 33, Firmware V3.0
Key Programming (VIN locked L322-06)
CAUTION
It is considered good practice to connect a power supply (Midtronic’s
PSC-550, CTEK MXS 25 or equivalent) to the battery when perfor
-
ming key programming. This will ensure that the battery voltage is
sufficient.
Note: Battery chargers are not suitable due to poor line regulation.
Regular non-Bluetooth IIDTool,
second hardware version
and
BT
/
Pro
only.
Figure 59.
Regular IIDTool generation
Preparation
•
Ensure all keys to be programmed are available.
•
Ensure the vehicle is unlocked
•
All the doors, including the boot, must be closed.
•
It is recommended to sit inside the vehicle with all the doors closed whilst this procedure is
performed.
•
Regular non-Bluetooth IIDTool,
second hardware version:
Usage of the PC-based control-
ler is mandatory. The IIDTool must be connected to the computer until the process is completed.
The option will be displayed on your computer screen. Please consult
of this user
manual for more details on the PC-based interface. If using a laptop, make sure the battery
charger is connected. Close all programs, disable all automatic updates and screen saver. The
computer does not need to be connected to the internet.
Instructions
Follow the instructions shown on screen to program the transponders. Once completed, the key fobs
(lock/unlock) will be programmed by following these instructions. When prompted by the tool:
• Switch the ignition on and then off again within 5 seconds
•
Remove key from the ignition
•
Ensure all doors are closed
Note
:
The following steps need to be completed within 30 seconds. Do not turn on the ignition until all
Summary of Contents for IIDTool Pro
Page 190: ...190 IIDTool Appendix...
