110
111
GAP Diagnostic 2019-07-15 All Rights Reserved
User Manual : Version 33, Firmware V3.0
•
The current (top) and new calibrations (bottom) of each sensor is shown here. It is an arbitrary
constant and does not refer to the height measurement. This new calibration value will only
change when the send button is pressed. The current height value is shown in the middle.
Figure 56.
App
: Calibrations values
Steps:
Figure 57.
App
: Guided Calibration steps
•
The first corner to be calibrated is the front left corner (1).
•
Place your measuring tape as instructed and use the up and down arrows (2) to reach the requi-
red height (3).
Summary of Contents for IIDTool Pro
Page 190: ...190 IIDTool Appendix...
