Ganz ZN-S100AE, Hardware Manual

Page: 7 / 21

GANZ MPEG-4 Encoder Series Hardware Manual
2010/2-1 O 7
Single Stream Dual Stream Model
Video Input Video Loop-out Video Input Video Loop-out
ZN-S100AE Vin1 - - -
ZN-S1000AE Vin1 Video Loop-out - -
ZN-S2000AE Vin1, Vin2 T-BNC Connector Vin1 Vin2
ZN-S4000AE Vin1, Vin2,
Vin4
T-BNC Connector Vin1, Vin3 Vin2, Vin4
Table 3. Video Connector Usage
Termination Resistor DIP Switch may be applied, when Video Input BNC Connector is
used for video loop-out.
T-BNC connector is not included in GANZ encoder package.
⑤
Termination Resistor DIP Switch (75 Ω ON)
A switch to turn ON/OFF a 75 Ω termination resistor is provided for each video input. Factory default
setting is ON. If impedance is mismatched between video inputs and outputs that are connected
together, you need to turn this DIP switch on/off to match the impedance to 75
Ω .
⑥ Video Output BNC Connector (Vout - Only ZN-S4000AE)
Vout is used for ZN-S4000AE to display quad, switching view in external monitor.
⑦ Reset Switch (Reset)
Reset switch is used for restarting GANZ encoder or resetting GANZ encoder as Factory Default
(FD). Refer to ‘4.1. Factory Default Settings’ for detailed procedures.