36
Firmware Update procedure:
1. Save the firmware file to your computer.
2. Go to Setup > System > Maintenance in the camera’s Web page.
3. In the Firmware Update section, browse to the desired firmware file on your computer. C
lick O.K.
Do not disconnect power to the unit during the upgrade. The unit will restart automatically
after the upgrade has completed. (1~5 minutes)
4. If you suspect the firmware upgrade for the camera has failed, always wait at least 5-10 minutes
before restarting the upgrade process.
5. Dealer reserves the right to charge for any repair attributable to faulty upgrading by the user.
6. Always read the upgrade instructions available with each new release, before updating the firmw
are.
System Reset (Factory Default Reset)
There are two way to reset the acmera as factory default.
.
Using the Web Page
1. Go to SETUP > System > Maintenance.
2. Click Factory Default button and wait 1 minute.
Using the Reset Button on rear panel of the camera
To reset the camera to the factory default settings using the Reset Button:
1. Disconnect the power adapter or the network cable if PoE is used.
2. Press and hold the Reset button while reconnecting power.
3. Keep the Reset button pressed until the
Status Indicator
color changes to
RED
and
start blinking (which may take up to 15 seconds).
4. Release the Reset button.
5. When the Status Indicator changes to
Green
(which may take up to 1 minute), the
process is complete and the camera has been reset.
The unit will now have the
default IP address from a DHCP server. Use the “ADMIN tool” to find and
connect the camera .
