EG-4
Creating a Hole in the Ceiling or Wall
Make two holes for the screws affixing the camera body, and one hole for the
power and video cables.
* Use the supplied template to mark the appropriate mounting position on
the ceiling or the wall.
Mounting the Camera Body
Remove the body cover, and mount the
camera body to the ceiling or wall.
Align the housing to the holes you have
made, and use two screws to mount the
camera body.
* Choose screws suitable for the type of ceil-
ing or wall material. Screws with a diam-
eter of 4 to 5 mm is recommended.
INSTALLATION & ADJUSTMENT
2
1
3
• Running cable along
the ceiling or wall
surface
(Back of camera body)
Wall
Press open the perforated
section, and run the cables
through.
Connecting the Cables
Please refer to the diagrams below.
①
Connect the video cable from monitor to the equipped video cable.
* When not using the equipped video cable, con-
nect the video cable from monitor to the camera
as shown.
②
Connect the power cable.
* When using 12V DC, connect the positive (+) side to the side marked "DC
12V."
• When using 12V DC.
• When using 24V AC.
ATTENTION
①
Check if the power is off before handling the power cable.
②
When using DC power, check for proper polarity before connecting to power sup-
ply. Improper polarity may cause damage to the camera.
(EG)D3048/563PAL
03.10.6, 3:36 PM
Page 4
Adobe PageMaker 6.5J/PPC
