Ganz ZC-BNX4312NHA, User Manual

Page: 6 / 11

EG-6
Adjusting the camera direction
This camera can be easily adjusted for viewing in all directions. After
attaching the camera on the wall or ceiling, adjust camera for the desired
direction. Then tighten each locking ring and lock rings with an allen wrench
as shown in the picture below.
● To ensure the best low light performance, this camera has IR LED device to
change automatically to night mode when the environment gets dark. If the
high light source or some object re fl ecting very bright light is placed within
1m from the installed camera, it interferes with IR LED performance so that
Day & Night function may not perform at the optimum level. Ensure that the
fi eld conditions are suitable before installing the camera unit.
Connecting the cables
Connect the power and video cables.
Connect the video cable from the monitor and the coaxial video cable
attached to the camera body.
● For using DC 12V, connect DC jack from camera with power supply (CLASS 2
ONLY). If necessary, after cutting off DC jack from camera connect it with power
supply.
● For using AC 24V, after cutting off DC jack from camera connect it with power
supply (CLASS ONLY 2)
● Speci fi cation below is recommended as an Output rated capacity of Power
supply that is connected to camera.
Input power Voltage current
12V DC 12V DC ± 10% 500mA ± 10%
24V AC 24V AC ± 10% 400mA ± 10%
● Be sure to check that the cables are connected correctly before turning on
the power.
● Turning on the power when the cables are connected with incorrect polarity
may damage the camera.