![background image](http://html.mh-extra.com/html/ganz/pixelpro-series/pixelpro-series_installation-manual_561097015.webp)
PixelPro GXi Series
ZN-DN312XE Series Installation Guide
03-2014-A
15
④
Analog Video Out connection
Use a 75 ohm video coaxial cable to connect to a monitor’s analog video input and check the
camera’s connection and its image focus at the installation site. Be sure to press the output
configuration button (PAL/NTSC button) to see the video (Refer to “
3. PART NAMES
” to check
the location of the PAL/NTSC button). The factory default is ‘no video output’; Press once to
set the video to PAL, and press again to set the video to NTSC. Pressing the button again will go
back to ‘no video output’ mode, disabling the viewing through the analog video connection.
Note
i
Once the PAL/NTSC button is pressed, the video display lasts for 3 minutes
before it goes back to ‘no video output’ mode.
⑤
LAN connection
This is a RJ45 LAN connector for 10/100 Base-T Ethernet. Use the Ethernet cable (RJ45) to
connect the device to a hub or a router in the network. When the LAN cable is connected, the
orange LED light will become solid and green LED will blink every 250 millisecond. Refer to
“
Appendix (B). Power over Ethernet
” for more details.
⑥
Power Connection
The camera can be powered from either 12VDC or PoE. If the camera is powered via PoE, refer
to “
Appendix (B). Power over Ethernet”
for more details. To operate your camera using 12VDC,
make sure the polarity is correct before connecting the power cable. Incorrect connection may
cause damages to the device.
Green LED Orange LED
Video
GND
Red
Black
12V
Red
Black
Summary of Contents for PIXELPRO SERIES
Page 1: ...03 2014 A 1 ...