6
www.gantner.com
Valid from June 10th, 2015 • Technical data subject to modification without notice!
DB_GAT-ECOSide-Lock7000--EN_11.indd • Part No. 642832
Mounting on Glass Doors
3
3
1
7
5
50
mm (1.9´´)
6 mm (0.24´´)
94 mm (3.7´´)
Loc
ker door (glass)
74 mm (2.91´´)
17 mm
(0.67´´)
14.6 mm (0.57´´)
11 mm
(0.43´´)
4
9.4 mm (1.94´´)
3
8.6 mm (1.52´´)
2
12
12
7
2
Loc
ker wall
17.6 mm (0.69´´)
16.4 mm (0.64´´)
1
3
3
3
3
Installation procedure
Note:
Before installing all locks in a new locker system, a test installation
of at least one lock and a final function check must be performed.
Only once the functional testing is successfully completed may the
remaining locks be installed in the same way.
1. Drill 3 holes (3) for the GAT ECO.Side Lock 7000 into the locker wall.
2. Insert the batteries into the GAT ECO.Side Lock 7000 (see page 7).
3. Mount the GAT ECO.Side Lock 7000 with 3 screws (3) on the inside
locker wall.
Attention:
Use the correct screws according to the type of locker
material, max. Ø 4 mm (0.16´´). The maximum allowed
tightening torque of the screws is 2 Nm (1.47 lb-ft).
4. Use adhesive to attach the GAT NET.Lock BoltSet 7300 in the correct
position to the inside of the locker door. Ensure the bolt set and metal
support are screwed together before applying adhesive. GANTNER
Electronic GmbH has successfully tested the following adhesives:
For transparent glass doors:
Conloc UV 680 from EGO. Only suitable for transparent glass doors
without color-coating as this adhesive requires exposure to UV light
(i.e., daylight) to cure.
For non-transparent glass doors:
Conloc UV 683 and Conloc Aktivator 953 from EGO. This combination
does not require UV light to cure and is also suitable for opaque glass
doors (e.g., with painted or color-coated tint treatment).
Attention:
If comparable adhesives are to be used, test to ensure the
adhesive meets the strength requirements. Always follow
the adhesive manufacturer’s instructions.
5. A label (GANTNER standard design or custom design) can be
attached to the locker front. If a custom label design is used, ensure
that a transparent field for the LED light is included in the label design.
6. Test the locker door to confirm that it can close easily and the door
shackle inserts correctly into the GAT ECO.Side Lock 7000.
1. GAT ECO.Side Lock 7000
2. GAT NET.Lock Bolt Set 7300
3. 3 x mounting screws for the
GAT ECO.Side Lock 7000
5. Door contact
7. LED position
12. Metal support for glass door (included
in the GAT NET.Lock BoltSet 7300)
Installation requirements for GAT ECO.Side Lock 7000 and bolt set
Please pay particular attention to the following points:
- When the locker door is pressed shut, ensure there is no gap between
the bolt set (2) and the front of the GAT ECO.Side Lock 7000. Ideally
the bolt set should touch the front of the lock.
- The front side of the bolt set and the GAT ECO.Side Lock 7000 must be
aligned parallel to each other.
