GAT ECO.Side Lock 7000 BA / NW BA
Installation
28
HB_GAT-GAT-ECOSide-Lock7000-BA--EN_14
www.gantner.com
Installation Instructions for the GAT ECO.Side Lock 7000 BA and Metallic Doors
Complete the following steps to install the GAT ECO.Side Lock 7000 BA into lockers with metallic doors.
► Drill 3 holes (3 in Figure 3.11) for the GAT ECO.Side Lock 7000 into the locker wall inner side according to the
information in section "3.11.2 Installation Requirements for the GAT ECO.Side Lock 7000 BA and Metallic
Doors" and the measurements in Figure 3.11.
► Insert the battery into the GAT ECO.Side Lock 7000 BA (see section “4.2.2. Inserting the Battery”).
► Mount the GAT ECO.Side Lock 7000 BA with 3 screws (3) on the inside locker wall.
NOTE!
Use the correct screws according to the type of locker material, max. Ø 4 mm (0.16´´). The
maximum allowed tightening torque of the screws is 2 Nm (1.47 lb-ft).
► Cut out a section, 63.4 mm x 68.2 mm (2.5´´ x 2.69´´), in the inner wall of the locker door for the GAT NET.Lock
Bolt Set 7200 (8 in Figure 3.12).
► Drill 4 holes (6 in Figure 3.12) in the inner wall of the locker door for mounting the GAT NET.Lock Bolt Set
7200.
► Cut out a section, 67.6 mm x 94 mm (2.66´´ x 3.7´´), in the outer wall of the locker door for the label carrier (9 in
► Mount the bolt set onto the inside wall of the locker door using 4 screws.
NOTE!
Use pan-head metal screws, Ø 3.5 mm (0.14´´), screw length depends on locker door thickness. The
maximum tightening torque of the screws is 2 Nm (1.47 lb-ft).
► Push the label carrier onto the outside wall of the locker door. The label carrier will remain in place with the
lashes on the label carrier. To protect against manipulation, a screw can be used to fix the bolt set to the label
carrier.
NOTE!
Use a countersunk screw, Ø 2.9 mm (0.11´´). Screw length depends on locker door thickness, e.g., a
15 mm (0.59´´) thick door requires a 19 mm (0.75´´) long screw.
► A label can be attached to the label carrier on the front of the locker door. The label has a transparent (matt)
viewing window for the LED to shine through and can be ordered with a GANTNER design or customer-specific
design.
NOTE!
For customer-specific labels, ensure that a transparent field for the status
LED is incorporated in the design and that no metal foil or metal color are used.
Figure 3.14 - Label carrier with front label
► Test the locker door to confirm that it closes easily and that the door shackle inserts correctly into the GAT
ECO.Side Lock 7000 BA. The locker door must spring open without assistance after it is unlocked.
Summary of Contents for GAT ECO.Side Lock 7000 BA
Page 63: ......
