G&L MMC-A2, Hardware Manual

Page: 158 / 192

MMC 32In/32Out Option Module
150 MMC Hardware Manual G & L Motion Control Inc.
Figure 10-2: General I/O Port Breakout Box Dimensions
10.2.1 DC Output Operation
Each General I/O Port provides 16 source-only 24 Vdc outputs.
Each of the 16 outputs on the general I/O connector is a solid state
switch rated at 250 ma. An example of connecting the DC Outputs
to loads is shown in
Figure 10-3 .
Each port contains two groups of eight outputs: group A = output 1
through output 8, group B = output 9 through output 16. Each group
is capable of detecting a short circuit or over-current condition.
Table 10-4:
General I/O Port Breakout Box and Cables
a
Description Length Part Num-
ber
MMC Gen I/O Breakout Box N/A M.1016.25
32
MMC Gen I/O & Aux I/O Connec-
tor to Breakout Box Cable .3 M (1
ft)
M.1016.25
39
MMC Gen I/O & Aux I/O Connec-
tor to Breakout Box Cable .6 M (2
ft)
M.1016.25
40
MMC Gen I/O & Aux I/O Connec-
tor to Breakout Box Cable .9 M (3
ft)
M.1016.25
41
a. The Breakout Box for the General I/O connector can be attached to the “GEN I/
O” port on the MMC Control, and on the “GEN I/O A” and “GEN I/O B” ports
on the MMC 32 In/32 Out Expansion module. The pinouts on the terminal strip
interface provide a one-to-one transfer of the signals from the connector to the
respective pin(s) on the terminal block. The connector pins marked with the
“ground” symbol on the screw connector are connected to the “D” connector
shell for shield grounding purposes.
1.875”
2.625”
3.940”
1 22
23
44
5.312”