G&D VisionXS-F-DP-HR, Installation And Operation Manual

Page: 137 / 224

Initial configuration of the network settings
G&D VisionXS-F-DP-HR · 21
English
Initial configuration of the
network settings
A basic requirement to access the web application of the KVM extender is the con-
figuration of the network settings of the computer module and the console module.
The required configuration settings can be made directly at the console.
NOTE: In the default settings the following settings are preselected:

IP address of
Network interface A
:
address is obtained via
DHCP
(fallback: IP address 192.168.0.1)

global network settings:
settings are obtained via
DHCP
IMPORTANT: At the console, you can use the local hotkey ( default : Alt + Num ) to open
and configure the local OSD of the console module and the remote hotkey ( default :
Ctrl + Num ) to open and configure the remote OSD of the computer module.
During the starting process of the console module the settings of both hotkeys are
shown (see Starting process on page 17).