Installation
Installation
The
USB-CPU
is installed, in accordance with the following instructions, between
the PS/2 devices and the USB port of a PC or a G&D device:
1.
Connect the PS/2 keyboard to the interface
Keyb. PS/2
at the front side.
2.
Connect the PS/2 mouse to the interface
Mouse PS/2
at the front side.
3.
Use the USB cable (
A type jack
to
B type jack
) to connect a PC or a G&D device to
the interface
USB K/M - CPU In
at the rear side.
4.
The
USB-CPU
uses the bus-power of an USB high power (500 mA) port to work.
If you connect the
USB-CPU
to such a high power port, there is no power supply
pack necessary.
If you connect the
USB-CPU
to an USB low power (100 mA) port, the use of the
power supply pack is necessary. In this case, connect the power supply pack to the
interface
Power
at the rear side.
Mouse
PS/2
Keyb. PS/2
Status
Active
Figure 1 - front view
CPU In
USB K/M
5V DC/1A
Power
Figure 2 - rear view
After installing the
USB-CPU
, the device is operable.
G&D USB-CPU ·
5