Installation
G&D DVIVision ·
9
Installing the user module (DVIVision-CON)
Connecting the remote console
DVI/VGA Out:
Connect the console monitor to this interface.
If the monitor only provides an analog VGA input, connect the
DVI-I-HD15F
adapter
to this interface. Afterwards, connect the monitor’s VGA cable to the adapter.
USB Keyb.:
Connect the USB keyboard to this interface.
USB Mouse:
Connect the USB mouse to this interface.
Keyb.:
Connect the PS/2 keyboard to this interface.
Mouse:
Connect the PS/2 mouse to this interface.
Additional USB interfaces of the variants DVIVision
-ARU
and
-U
:
USB 1.1 Devices:
Any USB device can be connected with these interfaces. Two USB
interfaces are located on the back panel of the device, another two can be found on
the front panel. The data rate of the interfaces is 12 MBit/s (USB 1.1).
The USB devices are provided to the computer module (DVIVision-CPU) which is
connected to the computer.
Additional interfaces of the variants DVIVision
-AR
and
ARU
:
Speaker:
Connect the speakers of the console to this interface.
Micro In:
If desired, connect the microphone of the console to this interface.
RS232:
Connect the serial device to this interface.
The serial device ist provided to the computer that is connected to the computer
module (DVIVision-CPU).
Figure 5: Interfaces to connect the user console to the user module
Both mouse and keyboard of the remote console can
either
be connected as a PS/2
device or as a USB device.
