G&D DVI-Vision-IP-Fiber, Installation And Operation Manual

Page: 143 / 240

Using the Reset button
18 · G&D DVI-Vision-IP-Fiber
Using the Reset button
The Reset button is located between the Identification LED and the Power LEDs on
the front panel of the computer module and the console module.
This button enables you to reset the default settings as well as to temporarily deacti-
vate the netfilter rules.
Resetting the default settings
Pressing and holding the button during booting resets the default setting of the module.
1. Switch off the device if in operation.
2. Press and hold the Reset button on the front panel of the device.
3. Keep the button pressed and switch on the device.
4. Release the button as soon as the green Switch LED is fast blinking.
NOTE: As protection against pressing the button accidentally, it is located behind a
drilling in the front panel.
Use a thin, pointed item to press the button.
NOTE:
When carrying out this function at the console module, the data is reset on
the local OSD. After this function has been carried out at the computer module,
the default settings of the KVM extender listed on page 67 are reactivated.
NOTE: You can also reset the default settings using the OSD (see page 94) or the
Config Panel web application.
When using the web application to reset the default settings, it is possible to keep the
configuration of the network interfaces.