G&D DP1.2-VisionXG-Fiber Series, Installation And Operation Manual

Page: 89 / 156

Installation
G&D DP1.2-VisionXG-Fiber · 8
English
Installing the computer module
The computer, whose signals are transmitted to the remote console, is connected to
the DP1.2-VisionXG-Fiber-CPU computer module. A local console can optionally be
connected to the computer module.
Establishing a connection to up to two local networks
Network A: Insert a category 5 twisted pair cable (or better), which is available as acces-
sory. Connect the other end of the cable to the local network.
Network B: Insert a category 5 twisted pair cable (or better), which is available as acces-
sory. Connect the other end of the cable to the local network.
Connecting keyboard and mouse to the local console
USB K/M: Connect the USB mouse and/or the USB keyboard of the local console.
PS/2: Connect the PS/2 keyboard of the local console.
NOTE:
If desired, connect the network interface to up to two local networks. Now
you can not only access the Config Panel web application from those networks but
also send syslog messages to those networks.
NOTE: If you want to create a local console at the computer module, you can connect
either USB (interfaces USB K/M ) or PS/2 (interfaces PS/2 ) mice and keyboards.
If necessary, use the adapter MD6M-2xMD6F (A6400043) to connect a PS/2 key-
board and a PS/2 mouse.
ADVICE: Use the adapter MD6M-2xMD6F (A6400043) to connect a PS/2 keyboard
and a PS/2 mouse.
PS/2 USB K/M
RS232
Network A
Network B
Transmission
A B
DP Out DP CPU
Host
Link
USB 2.0 CPU
PS/2 USB K/M
Main Power Red. Power
Power
Red.
Main
Network A
Network B
USB 2.0 CPU
RS232
In Out
Line
Ready Ident.
System Fail
PS/2 CPU USB CPU