G&D DP1.2-Vision-Fiber, Installation And Operation Manual

Page: 125 / 152

Configuration
G&D DP1.2-Vision-Fiber · 46
English

Controller: The multimedia controller ShuttlePRO v2 is used to operate various audio
and video programs. A special USB keyboard mode lets you use the controller to
operate the computer connected to the target module:
 LK463 compatible keyboard:
You can connect an LK463 compatible keyboard to the
suer modules of the KVM matrix switch. The order of the 108 keys of these keyboards
corresponds to the OpenVMS keyboard layout.
A special USB keyboard mode guarantees that whenever a special key of this key-
board pressed, this action is transmitted to the target computer:
How to select a USB-HID mode:
Changing the scancode set of PS/2 keyboards
If you press a key at the PS/2 keyboard, the keyboard processor sends a data packet
that is called scan code. The two common scancode sets (sets 2 and 3) contain differ-
ent scancodes.
In the default configuration, the KVM extender interprets any entry made at the
PS/2 keyboard with the scancode set 2.
INPUT DEVICE SETTING
Contour ShuttlePRO v2

Contour SP2
INPUT DEVICE SETTING
LK463 compatible keyboard
 LK463
OSD
1. Press Ctrl+Num (default) to open the on-screen display.
2. Select the row Target setup and press Enter .
3. Select the row USB HID mode and press F8 key to select an option (see above).
4. Press F2 to save your settings.
Confi
g
Pan
el
1. In the menu, click on KVM extender .
2. Click on the KVM extender you want to configure and then click
on Configuration .
3. Click on the tab General and then on the tab CPU .
4. Select the desired option (see above) under USB HID mode .
5. Click on Save .