1. INSTRUCTION
Led Par Light
Unpacking:
Thank you for purchasing our products. Every unit has been thoroughly tested and
has been shipped in perfect operating condition. Carefully check the shipping carton for damage
that may have occurred during shipping. If the carton appears to be damaged, carefully inspect
your fixture for any damage and be sure all accessories necessary to operate the unit has arrived
intact. In the case damage has been found or parts are missing, Save the carton and all packing
materials. In the event a fixture must be returned to the factory. It is important that the fixture be
returned in the original factory box and packing.
Introduction:
The unit is a DMX intelligent Led Par Light. This light can be used in a stand alone
mode or connected in a Master/Slave configuration. The unit can also be controlled via DMX
controller. This light has three operating modes: stand alone mode, Master/Slave and DMX control
mode.
AC Power:
This fixture has an auto-switching power supply that can accommodate a wide range
of input voltages. The only thing necessary to do before powering on the unit is to make sure the
line voltage you are applying is within the range of accepted voltages. This fixture will
accommodate between 90V and 240V AC. All fixtures must be powered directly off a switched
circuit and cannot be run off a rheostat (variable resistor) or dimmer circuit. Even if the rheostat or
dimmer channel is used solely for a 0-100% switch.
Safety Instructions:
➢
To reduce the risk of electrical shock or fire, do not expose this unit rain or moisture
➢
• Do not spill w
ater or other liquids into or on to your unit.
➢
• Be sure that the local power outlet ma
tch that of the required volt-age for your unit.
➢
• Do not attempt to operate
this unit if the power cord has been frayed or broken. Do not
attempt to remove or break off the ground prong from the electrical cord. This prong is used to
reduce the risk of electrical shock and fire in case of an internal short.
➢
• Disconnect from main power before making any type of connection.
➢
• Do not remove the cover under any conditions.
There are no user serviceable parts inside.
➢
• Never operate this unit when it’s cover is removed.
➢
• Never plug this unit in to a dimmer pack
➢
•Always be sure to mount this unit in an area that will allow proper
ventilation. Allow about 6” (15cm) between th
is device and a wall.
➢
• Do not attempt to operate this unit, if it becomes damaged.
➢
•
This unit is intended for indoor use.
➢
• During long periods of non
-
use, disconnect the unit’s main power.
➢
• Always mount this unit in safe and stable matter.
➢
• Power
-supply cords should be routed so that they are not likely to be walked on or pinched
by items placed upon or against them, paying particular attention to the point they exit from
Please read these instructions carefully, which includes important information
about the installation, usage and maintenance of this product.
