2. Setup and Operation
Using the LCD Menu and Buttons
The Orux 480 Z features a standard LCD screen and buttons for operation. Press
Menu
to enter the menu. Use the
Up
and
Down
arrows to navigate through the options and
press
Enter
to go into the menu or confirm your selection. The menu will automatically
exit after a period of inactivity.
Address
001-512
Set the DMX Address
Info
Software Version
Displays the Software Version
IP Info
Displays the IP Address and Subnet Mask (Not En-
abled on the Orux 480 Z)
Time Info
Current Time
Displays the Run Time since
powered on.
LED Run Time
Displays the total LED “On” time.
Total Run Time
Displays the total powered-on
time over the life of the fixture.
Ethernet
(Not Enabled on the
Orux 480 Z)
(Not Enabled on the Orux 480 Z)
Set
Display Reverse
“ON” will reverse the display for hanging fixtures.
User Time
N/A
Language
Set Language – English or Chinese
Reset Default
Set the fixture to the factory default settings
Motor Reset
Offers options to reset each individual motor inside the
fixture separately.
Calibrate
Allows for calibration of individual parameters. Contact
GAMMA LED Vision for password if required. Most
users should never need this :)
Fan Set
Silent
Set fans to silent/quiet mode
High
Set fans to high
Auto
Set fans to automatic/balanced
Encoders
Turn off or on the Pan/Tilt correction encoders.
Tilt Reverse
Turning this “ON” reverses the tilt of the light.
Pan Reverse
Turning this “ON” reverses the pan of the light.
Dimmer Curve
Square Law (De-
fault)
Sets the dimmer curve to the de-
sired option. Most users should
leave this alone :)
S Curve
Linear
Orux 480 Z – GAMMA LED Vision
Page 8 of 23
