SLM FACE PLATE INSTALLATION
Remove the tape covering the opening on
the front side of the bottom cover to expose
the string length meter.
Position the face plate assembly over the
opening in the bottom cover, and align the
two countersunk end holes of the face plate
with the threaded attachment holes in the
front of the string length meter. With the two
flat head machine screws, secure the face
plate assembly to the string length meter.
To check for proper alignment, lift the top
clamp of the face plate assembly and insert
a section of racquet string at least 12 inches
long into the entrance hole of the face plate.
Continue feeding the string section into the
string length meter, until it appears through
the exit hole. If the entrance or exit holes
appear to be blocked, loosen the attachment
screws and adjust the position of the face
plate assembly until the section of string
exits the face plate. After the face plate is
properly aligned, tighten the flat head screws.
8
