Gamko MAXIGLASS MG3, User Manual

Page: 31 / 68

31
Maxiglass MG3 - LG3
Troubleshooting
Attention
The cabinet does not start
Temperature is too high, in spite of recent adjustment of thermostat
Temperature is too low, in spite of recent adjustment of thermostat
Water leak
Thermostat notifications
ECO mode
Always remove the plug from the socket when carrying out repairs.
• Check the plug.
• Restore the power supply by replacing a fault fuse or by using the on/off switch.
• Contact your local service organisation.
• Check/restore power supply.
• Remove contents which may obstruct ventilation.
• Clean magnetic seal, or gasket, replace if necessary. Remove contents which may obstruct ventilation
• Defrost evaporator.
• Thermostat or compressor is defective.
• Fan (evaporator or condenser) is defective.
• Contact your local service organisation.
• Thermostat is defective.
• Contact your local service organisation.
• Defrost regularly – if necessary extra manual defrost cycle.
• Check if the appliance is level. If necessary, level the appliance.
• Contact your local service organisation.
• The code P1 appears in the display.
• Inform the Gamko service department or your supplier.
• The lighting switches on or off at unwanted moments. The controller has a self-learning ability to save
energy.
• The ECO modes can be deactivated with irregular use. See section thermostat