–
FAST RELOAD MOD – PROGRAMMING A MODE
The Fast Reload Mod has 5 Programmable Modes. Note: Start around a setting of 22 and go from there!
Once you are in the Mode you wish to Program, Hold Down the Square Button and Hold Down Up on D-
Pad until the PS4 LED begins to flash, then Release the Square Button . The PS4 Controller LED will
flash 5 times letting you know that you are now in Programming Mode.
Once in Programming Mode you can adjust the timing of the Fast Reload Mod. Please follow the steps below to
optimize the timing for Fast Reload.
Step 1: Go into a game; choose a load out with the weapon you want to configure Fast Reload for. Be aware
that perks like slight-of-hand cannot be used with the Fast Reload Mod.
Step 2: Choose the Fast Reload Mode you would like to Program (Refer to Page 12 “Fast Reload Mod – Choosing
a Mode”)
Step 3: Enter Programming Mode (See Above)
Step 4: Tap Up on the D-Pad to Increase or Down on the D-Pad to Decrease the time to optimize
Fast Reload timing. After every adjustment you can test the setting it by Tapping the Square Button .
The way Fast Reload works is by eliminating animation time. You are trying to set Fast Reload timing at the
point where he puts the clip in, the swap weapons glitch happens and your clip ends up fully loaded without
waiting for the extra animation of the reload. Increase the speed (Up on D-Pad ) and keep testing until the
full reload does not happen. Then decrease the speed (Down on D-Pad ) until it's fully reloading your clip
again. This will bring you to the fastest possible speed for the mod. Remember, every weapon is different so
there is no "one size fits all” setting.
By default, all 5 Modes of Fast Reload are configured for the SVU in Call of Duty Ghosts with no perks on that
affect the timing.
Step 5: Once you have found the ideal setting, Tap Right on D-Pad to save the setting and the LED will flash
the corresponding amount of times for that setting. For example, a Setting of 22, will flash the LED 22 times.
Note: To setup a different Fast Reload Mode, simply enter the mode and repeat the programming process
above.
, then
, then
Until LED
Begins to Flash
