Instruction Manual : 10’ BLIND TOWER
4
WARNING
Do Not use this product until you have watched the
safety video, understand it, and practiced the techniques
for safe hunting discussed in this video. The video can
be found with the QR code and/or URL shown on front
cover of this manual.
Read and perform all inspection and maintenance tasks
before each and every use. Replace any questionable
components immediately with RETI original replacement
parts.
Do Not crush tubing when tightening bolt assemblies!
Identify and familiarize yourself with all parts before you
start. Bolt identification chart can be found in the back.
Double check assembly steps to be certain you have
correctly assembled this product.
Never use any product that has not been maintained or
inspected properly - Your life depends on it!
Always wear the appropriate footwear when using a free
standing platform stand. A good non-slip safety boot is
important to your personal safety. Be especially careful
that boot laces do not get hooked on the stand or any
of its components (tuck shoelaces into boots before
climbing).
Do not position this product on a slope, unlevel, or wet
ground. It may tip over and serious injury or death may
occur.
Ground must be free of rocks and debris so stakes can be
driven into ground through holes provided in foot pads. This
will help prevent tower from tipping over in strong winds.
Contacting buried utilities may result in serious injury or
death! Before digging always call 811 or you local One-
Call system to prevent person injury, interruption of
service, environmental accidents or project delays.
Heavy product, Always use at least four (4) people to
install or take down a free standing platform stand. Do
Not let someone with a history of back problems help.
READ AND UNDERSTAND THE FOLLOWING WARNINGS BEFORE SETUP AND USE
STOP
WARNING
Be sure only one person ascends or descends ladder at a
time. Be certain first person is fully off of the ladder and
positioned safely on tower platform or ground before
second person ascends or descends ladder.
Never have two people on one side of the platform. Keep
weight evenly distributed on platform.
Always be aware of the other person’s position. Use
extreme caution when weapons are used to prevent
personal injury.
Always lean forward as you climb ladder or climbing aid.
Always maintain three (3) points of contact when
climbing a ladder treestand or free standing platform
stand. Proper three-point contact means having either
two feet with one hand or one foot with two hands on
the step portion of the ladder or climbing aid at all times.
Always wear the appropriate footwear when using a free
standing platform stand. A good non-slip safety boot is
important to your personal safety. Be especially careful
that boot laces do not get hooked on the stand or any of its
components (tuck shoelaces into boots before climbing).
WARNING
Double check assembly steps to be certain you have
correctly assembled this product.
Study your new stand to become familiar with all of its
features and design. Save these instructions for future
reference.
Be Sure assembly area is open, flat, level, and dry with no
power lines near!
Always use at least four (4) people to install or take down
a free standing platform.
Do Not use any type of motorized vehicle to upright/
assemble this free standing platform stand. You could
cause unnecessary damage to this product. Upright by
hand only using four people.
Some models include a shooting rail. Never lean against,
lean over, or sit on shooting rail. It is designed as a shooting
rest only. On models that have a non-fixed shooting rail,
be sure shooting rail is flipped back or swung to the side
when ascending or descending ladder.
