Assembly & Installation Instructions
Step 6:
Install Roof Top Supports into welded
receptacles on the roof frame as
shown in Figure 6.
Step 7:
At ground level
slip the Camo Skirt
and Roof over the previously installed
Frame. Make certain the sewn seams
line up with the roof frame. Connect
the Camo Skirt and Roof to the
frames using the Hook & Loop
Fasteners as shown in Figure 7.
7
Care and Maintenance
It is recommended that you store your accessory kit out of sunlight and out of any other harsh
environmental condition(s) that may adversely affect its performance.
Step 5:
At ground level
install assembled
Roof Frame to the Tandem
Ladderstand’s Arm Rests.
A:
Install Rear Vertical Support Bars
(4) onto Arm Rests using four (4)
M6x85 Bolts, eight (8) Steel Washers,
four (4) Thick Nylon Washers and four
(4) Nuts as shown in Figure 5.
B:
Install Front Vertical Support Bars
(5) onto Arm Rests using two (2)
M6x65 Bolts, four (4) Steel Washers,
two (2) Thick Nylon Washers and two
(2) Nuts as shown in Figure 5.
Note: Please place one (1) Thick
Nylon Washer between the Arm
Rest and Vertical Support Bars.
Figure 7
Figure 6
Figure 5
Care and Maintenance
It is recommended that you store your accessory kit out of sunlight and out of any other harsh
environmental condition(s) that may adversely affect its performance.
M6x85
(For Step
5-A)
M6x65
(For Step 5-B)
Summary of Contents for 158239
Page 5: ......
