Gambro COBE 2991, Essentials Manual

Page: 182 / 273

4-2 COBE 2991 Cell Processor • Essentials Guide
LED Programming
LED Program Board Overview
The LED program board (Figure 4-1) is capable of storing up to 10 programs, with
as many as 7 cycles for each program. The LED program board is used only in the
Automatic mode.
The following parameters can be programmed for each cycle:
• TIME (00.0 to 99.9 minutes)
• R.C.O. (red cell override)
• STOP SELECT [CALL, P.C. (packed cells), or R.C. (resuspended cells)]
• VALVE SELECT (valve 1, 2, or 3, or no valves)
Before you begin processing in the Automatic mode, you must select an existing
program or create a new program.
Figure 4-1: LED program board
The LED program board incorporates a program protection feature that prevents
unintentional modifications to memory-stored programs. See “Program Protection”
on page 4-9.
Program
Up to ten protocols, each identified by a selected program number (numbered 0 to
9), may be stored in memory. A program is selected using the arrow keys (located
below the PROGRAM LED).