Gambro AK 98, Operator'S Manual

Page: 175 / 386

HCEN12745 Revision 10.2016
Program version 2.xx
AK 98 Dialysis Machine - Maintenance handling A:173
3) Hold the handle and place the rotor on the
pump shaft.
4) Grip the rotor and slowly turn it clockwise
at the same time as you push slightly.
5) Continue turning until the blood pump
handle clicks in.
13.3 Clean the blood leak detector
The detector easily becomes contaminated when the cover is open. The blood leak
detector should only be cleaned, after a blood leakage alarm that is suspected to be
false.
Procedure
1) Make sure the dialysis machine is turned
off.
2) Open the cover.
3) Clean the lenses with a soft lint-free cloth,
moistened with disinfectant solution.
4) Make sure the sealing ring on the inside of
the cover is in place.
5) Close the cover.
13.4 Water inlet tube
The tube between the water supply system, and the tube into the dialysis machine, are
not automatically disinfected by the local disinfection program. It requires either an
integrated disinfection together with the water delivery system (see Section 10.3.8.1
“Integrated heat disinfection with a WRO 300 H unit” on page A:149) or a manual
disinfection procedure performed by an authorised service technician.
13.5 Pick-up tubes
The pick-up tubes can be soiled by salts and concentrates . After each treatment,
flush the pick-up tube with water. Let them dry naturally – do not wipe them.