G
AMATRONIC
E
LECTRONIC
I
NDUSTRIES
L
TD
.
10
P+ PREMIUM 60, Installation Guide,
rel.
1.4
6.
The metal plate can now be pushed inwards for about 2 cm (3/4 inch), uncovering 2 nuts and bolts on
the left and 2 on the right (Figure 10). These are 2 of the 4 bolts holding each wheel in place.
Each front wheel is attached by 4 bolts. Two of the bolts can be easily seen; the other two are under
the metal plate.
Figure 10: Push the plate in to expose 4 nuts and bolts
7.
On the right front side, remove the 4 bolts with an 11 mm wrench. Two of the bolts are easily visible,
and two are hidden under the metal plate . After removing the bolts the front right wheel can be
removed. Then do the same thing on the left front side: remove the 4 nuts and bolts, then remove the
left front wheel.
Figure 11: Removing the 4 bolts of the right front wheel