page 4
replacing the batteries
warning: Do not dispose of
Li-Ion battery in the regular
trash, municipal waste stream
or by fire as batteries may leak
or explode. Do not open, short
circuit, or mutilate batteries as
injury may occur. Preserve our
environment by recycling Li-Ion
batteries or disposing of them
in accordance with local, state
and federal regulations. Do not
mix old and new batteries.
maintenance
Clean the solar module regularly with a damp towel to guarantee
optimum performance of the solar panel. Do not use any type of
solvent for cleaning and be careful not to put too much pressure
on the module while cleaning.
trouble Shooting
If your solar charged light does not come on at dusk despite
observance of all the instructions, please try the following steps:
1. Make sure that the solar light is not being affected by
any other light source (i.e street lights).
2. Ensure the solar light is not positioned in the shade during the day.
3. Make sure the switch in the lamp head is in the” ON” position.
4. Check that the batteries are installed correctly.
5. Check that the GS Solar LED Light Bulb is installed correctly.
note: The performance of the solar light will vary with the time of year. It will deliver longer
duration when it has had a full day in the sun rather than a day in overcast weather.
wintertime tipS: Keep snow and debris cleaned off the solar panels so the batteries can
recharge. If the lights are covered with snow for an extended period of time, after the snow
melts, allow all the batteries to charge in full, direct sunlight for at least 6 hours to their
maximum capacity.
warning: Please keep out of reach of children.
Fig. 3
replacement batteries are available at www.gamasonic.com or via
our toll free number: +1-800-835-4113
1. Make sure the H/OFF/LOW switch is in the “OFF”
position.
2. Unscrew the two screws on the top part to
detach it from the body part (Fig. 3).
3. Unscrew the battery compartment’s screws
located on the silver reflector and remove the
compartment doors (Fig. 3).
4. Unclip the battery connector and
remove the old battery. Make sure
the new batteries are high quality –
Li-Ion Battery packs (3.2 Volt / 3000
mAh) with connector.
5. Install the new batteries into the battery
compartment.
6. Reassemble the unit by reversing the above procedure.
