page 3
1. Using the mounting
bracket as a template, mark
where the two holes will
need to be to hang your
light.
2. Using a drill, make two
holes where those marks
are and insert the wall
anchors.
3. Place the bracket in line
with the holes and secure
with the provided screws.
(make sure the bracket is
installed so the two tabs
are not against the wall)
4. Install the lamp onto the
bracket making sure the
two tabs slide into the
grooves on the back of the
lamp.
1. Make sure the lamp is in the OFF (O)
position (Fig. 1).
2. Detach the back of the lamp unit (B)
by removing the 2 screws at the base
of the lamp (Fig. 2).
3. Remove the existing bulb by turning it
counterclockwise (Fig 3). (If Replacing)
4. Install the new GS Solar LED Bulb by
turning it clockwise into the bulb socket
5. Reassemble the unit by reversing the
above steps.
6. Make sure the High/OFF/Low switch is in
the ON (High) or (Low) position (Fig. 1).
Make sure the new bulb you purchase is
compatible with this model (C37 bulb)
Operation Instructions
Installation Instructions (Fig 4)
Fig. 1
Fig. 2
SCREWS
Fig. 3
Fig. 4
