Version 1, 6
th
April 2021, Page
2
of
5
INSTALLATION
1. Drill attachment holes
- Drill ø15 mm holes in the wall to suit the
M10 fixing studs. The positions are
marked in the figure above.
2. Insert studs to the mirror
- Fit the four M10 fixing studs to the
threaded inserts on the back of the
mirror and hand tighten.
3. Attach studs into wall holes
- Lift the mirror into place passing the
studs through the holes in the wall and
ensure the mirror sits flat.
Note: The mirror weight is 10 kg. Always use safe
lifting procedures when lifting heavy loads.
4. Attach washer and nuts
- Place a washer and M10 nut onto each
stud and tighten, ensuring the mirror sits
level. (Tighten each nut to 10Nm)
