Version 1, 4 February 2020, Page
2
of
4
PRE-INSTALLATION -
MOUNTING DETAILS
If the mounting holes do not already exist, mark out and drill the holes in the wall/sheet, as shown in rough-in
dimensions.
Note: Before installation, all lines must be flushed. We recommend that a line strainer be installed prior to drinking taps to
eliminate any foreign material
.
Rough-In Dimensions
INSTALLATION
IMPORTANT: Galvin Specialised products must be installed in accordance with these installation instructions and in accordance with
AS/NZS 3500, the PCA and your local regulatory requirements. Water and/or electrical supply conditions must also comply to the
applicable national and/or state standards. Failing to comply with these provisions shall void the product warranty and may affect the
performance of the product.
1. Fit tap assembly
Fit wall plugs to wall as per the rough-in dimensions.
When applying thread tape or sealant to the inlet, ensure the
opening is not obscured. Failure to do so may restrict or
block the flow restrictor, affecting the flow of water.
Screw tap onto existing spud until the flange is touching the
wall.
Ensure the mouthguard is in the correct position and the
holes in the flange align with the wall plugs.
2. Secure the body
Secure the body with supplied screws.
