Galvanic Applied Sciences MONITEK MESSENGER, User Manual

Page: 77 / 87

-75-
Automatic Mode:
Choose Cleaning Event 1...2
Specify the
Cleaning Frequency, Cycle Duration , and Purge Time.
The Cleaning Event gets activated once you save the settings.
Assign Digital Inputs:
Choose Cleaning Event 1…2
Set Cleaning Frequency in Hours = 0
Specify the
Cycle Duration , and Purge Time. Save the settings. Activate the Relay
through Assign Digital Inputs. The Cleaning Cycle gets activated ONLY ONCE.
When you are trying to activate a Cleaning Event through Assign Digital inputs
make sure that the Cleaning Frequency in Hours is 0. Failing to do so may cause
malfunctioning of the Cleaning Event.
6.6.7 Set Access Code
You can set Personal Access code for Operator, Technician and Factory Levels
preventing unauthorized personnel from altering key parameters that affect the
operation of the unit.
Choose Operator text box. An Interface pops up Specify the Operator Password.
Choose Technician text box. An Interface pops up Specify the Technician
Password.
Choose Factory text box. An Interface pops up Specify the Factory Password.
6.6.8 Set Access Level
You can enter the Access code based on the access code entered access level
changes.
Choose New Access Code text box. An Interface pops up Specify the new
Access code.
Note:
On entering incorrect access code the Access Level will be defaulted to
Operator.