Galvanic Applied Sciences AccuChrome MA2963, Operation Manual

Page: 93 / 145

Revision 4 80 12/15/2018
6.2.3 Generating Reports
A range of reports can be generated via the Reports tab (Figure 6-4). Select the desired
report format (Print, PDF, Open File) and press the button that describes the report that you
want.
Figure 6-4: The Report Tab
6.3 Setting up the Desired Analysis
In addition to the activities described in the View mode, the Edit Mode allows the user to edit
a broad range of operating parameters, calibrate the system, establish a data collection
schedule and setup Modbus parameters.
Typically, the system operating parameters are established during manufacturing and/or
during installation. It is not necessary to edit most of them unless a major change in the
overall system configuration is made. In this section, we will describe only those activities
that are likely to be performed. As an example of this point, the nature of each stream
(sample, calibration, reference) is indicated in the Streams Setup tab. In normal operation,
once the system is configured, the nature of the gases delivered to the chromatograph is not
changed.