Galvamet SLIVER, Manaul, Page: 8 / 20

The hood must be cleaned immediately after installation and
the removal of the protective film in order to eliminate any glue
residues and other potential impurities.
The hood must be cleaned regularly and carefully, both inside
and out (at least once a month).
Do not allow dirt to accumulate on the external and internal
surfaces of the hood.
Do not use acid or base products or abrasive sponges to clean
the external frame.
Clean the hood with a sponge dampened with warm water and
a small quantity of neutral detergent (e.g. washing-up liquid) to
eliminate any traces of fat that may have deposited on it.
Rinse with a damp cloth, removing all detergent carefully,
following the direction of the satin finish of the steel surface.
Drying, above all in the areas where water is very hard and
leaves scale deposits, is particularly important.
The hood is fitted with a LED lamp that, apart from guaranteeing
good lighting and considerable power savings, ensures an
average life 10 times longer than traditional lamps. If it must be
replaced, contact the service centre.
EN