Gallien-Krueger Microbass MB150E/112 Owner'S Manual Download Page 11

11

MicroBass-III Series

 

Low Noise Operation:

The MB-III Series uses a high gain, high head-
room, low noise input stage.  It has such a large 
dynamic range (60v p-p) that very few instruments 
can overdrive it.  Even most basses with “active” 
electronics do not need to use the -14dB input pad.  
The benefit to you is less hiss and much less noise 
over all.

The Valve Effect:

As in all GK amplifiers, the MB-III Series preamp 
incorporates what we call the Valve Effect, or 
G.I.V.E(Gate Induced  Valve Effect).  We  use field 
effect devices with the gate biased in such a way 
that emphasizes the optimum harmonic content of 
the signal. Working in concert with our unique Four 
Band Active Equalizer, and three stage Voicing Filter 
Section, the Valve Effect produces a consistently 
pleasing bass tone.

Cool and Reliable Class “H” Design:

The MB-III uses a “dual rail” power supply (class 
H) that generates about half the heat of conven-
tional amplifiers.  Low output signals run off of a 
low voltage supply keeping the amp running cool.  
When the signal exceeds a certain level, the amp 
switches to its high voltage supply until the higher 
signal level drops back down.  By using a Class 
‘H’ power supply  it eliminates the need for a fan.  
Convection cooling is used instead for completely 
silent operation in the studio or on-stage.  This 
well thought out design helps make- the MB-III 
the little amp with the big sound.  

Intelligent Protection Circuitry:

The MB Series protection circuitry constantly 
monitors for unsafe operating conditions such as 
short circuits, miss-wired speaker cables, blown 
speakers, improper ventilation, and incorrect speaker 
configurations.  In addition,  protection is provided 
during power up/down.  If the amplifier senses any 
unsafe operating conditions, the output signal is 
immediately muted and the power light changes 
from Blue to Red.  The amplifier will remain muted 
until the fault is removed.  If the protection circuit 
activates while  playing, turn the amplifier off and 
check the speaker output.  If the problem persists, 
contact GK directly for technical advice.     

T

e

c

h

 T

alk

In Closing:

You should now have a thorough understanding of 
how your new MicroBass Series amplifier works and 
the advantages it offers in dialing in ‘your’ sound.  
We thank you for reading the Owner’s Manual and 
wish you the best of times!  Please send us your 
comments via the web at www.gallien-krueger.com 
or email us at [email protected].

Summary of Contents for Microbass MB150E/112













Reviews: