MPED
46
1
MPED 07 - 08
2
All copying, even partial, of this manual is strictly forbidden
RG66012163 - Rev 00
15
INSTALLATION CLEARANCE REQUIREMENTS AND SITING
To guarantee the proper functioning of the unit and access for maintenance purposes, it is necessary to comply with the minimum installation clearance
requirements shown in figures 1, 2, 3 and 4�
There must be no obstacles blocking the path of the air flow from the fans�
Avoid any and all situations of backflow of hot air between air outlet and inlet of the unit�
If even only one of the above conditions is not fulfilled, please contact the manufacturer to check for feasibility�
In the design of the MPED series, special care has been taken to minimise noise and vibrations transmitted to the ground�
Even greater insulation may be obtained, however, by using vibration damping base supports (available as optional accessories)�
If vibration damping base supports are adopted, it is strongly recommended also to use vibration damping couplings on the water pipes�
Whenever the unit is to be sited on unstable ground (various types of soil, gardens, etc�) it is a good idea to provide a supporting base of adequate dimensions�
Warning
heat pump units produce condensation while operating in the heating mode�
MPED water chillers and heat pumps are air-cooled units suitable for indoor installation� It is necessary to install air intake and outlet ducts that must be
sized for the nominal air flow rate and the available useful pressure of each model� At the same time avoid installations that may allow air recirculation to
take place between the intake and the outlet�
The figure shows a typical installation with air outlet from above�
It is important to bear in mind the following aspects when choosing the best site for installing the unit:
-
size and origin of water pipes;
-
Location of the power supply;
-
Solidity of the supporting surface;
-
To position the unit so that prevalent winds do not alter the fan air flow)�
-
Avoid the transmission of noise and vibrations through the technical compartment and duct structure� To do this, use base vibration damping
accessories and vibration dampers on the air outlet� If vibration damping base supports are adopted, it is strongly recommended also to use vibration
damping couplings on the water pipes�
-
Ensure proper accessibility for maintenance or repairs�
This device is not intended to be used by children or by people with physical, sensory or mental impairments, except under supervision. Make sure
that children do not have access to the device.
HEAT EXCHANGER WATER CONNECTION SIDE
EX
CHANGER SIDE
ELECTRICAL BOX
FAN SIDE