EN
EN - 41
Installation
Take microwave oven out of the box. Remove all packing material and accessories empty
the inside of the oven. Examine the oven for any damage such as dents or broken door.
Do not install if oven is damaged.
Cabinet:
Remove any protective film found on the microwave oven cabinet surface.
Do not remove the light brown Mica cover that is attached to the oven cavity to protect
the magnetron.
1) Select a level surface that provide enough open space for the intake and outlet vents.
2) minimum clearance of 20 cm is required between the oven and any adjacent walls.
20cm
30cm
20cm
min85cm
0cm
3) - Leave a minimum clearance of 12 inches (30cm) above the oven.
- Do not remove the legs from the bottom of the oven.
- Blocking the intake and outlet openings can damage the oven.
- Place the oven as far away from radios and TV as possible.
Operation of microwave oven may cause interference to your radio or TV reception.
4) Plug your oven into a standard household outlet. Be sure the voltage and the frequency
is the same as the voltage and the frequency on the rating label.
WARNING:
Do not install oven over a range cooktop or other heat-producing appliance. If
installed near or over a heat source, the oven could be damaged and the warranty would be void.
The accessible surface may be hot during operation.
Don´t touch on !
CONTROL
1. CLOCK SETTING
When the microwave oven is electrified,the oven will display “
0:00
“, buzzer will ring once.
1) Press “
CLOCK/PRE - SET
”, the hour figure flash.
2) Turn ” ” to adjust the hour figures, the input time should be within 0 - 23.
3) Press “
CLOCK/PRE - SET
”, the minute figures will flash.
4) Turn ” ” to adjust the minute figures, the input time should be within 0 - 59.
5) Press “
CLOCK/PRE - SET
” to finish clock setting. “
:
“ will flash.
Note:
a) If the clock is not set, it would not function when powered.
b) During the process of clock setting, if you press “
STOP/CLEAR
“, the oven will go back to
the previous status automatically.