Gallet BOU 630 Nantes, Instruction Manual, Page: 18 / 36

ENG - 18
• Let the kettle cool down completely before cleaning or storing.
• Unplug the unit when not in use, before filling in /pouring out water, moving from one location
to another or before cleaning.
• Do not allow the cord or the product itself to touch hot surface and make sure it is placed in
such a way that the unit cannot accidentally be upset by anyone pukliny the power cord.
• Do not operate the product with the damaged cord or plug. Never try to repair on your own.
Cord or plug replacement should be done in authorized service center only.
• Do not operate the kettle if it has been dropped or damaged. Take it to an authorized service
center for examination and repair.
• Never disassemble the product; incorrect reassembly can increase the risk of electric shock
when the kettle is used. All repair work should be carried out only by an authorized service
center.
• Do not use the kettle without filter.
• Do not use the appliance outdoors.
• The appliances are not intended to be operated by means of an external timer or separate
remote-control system.
Important !
• As there is the risk of burns, always close the lid and lock it properly when you are going to
turn the kettle on. Never open the lid while hot water is inside and /or the steam density is too
high.
• The lid or outer surface may get hot when the appliance is operating. The temperature of
accessible surface may be high when the appliance is operating.
• Before switching on the kettle ensure that the water level is between MIN and MAX marks
only.
• There is a cut-off device that works if the kettle is overheated. It switches the kettle off when
there is no water inside or the water level is too low. Wait until the kettle cools down comple -
tely to start boiling after the cut-off device was activated. The kettle will not turn on while too
hot. Before switching on the kettle always check that there is water inside the kettle and the
water level is not too low.
• Fill the kettle with cold water only.
• Switch the kettle off before removing it from the base.
• The kettle must be used only with the base provided.
• If the kettle is overfilled, boiling water may be ejected. Don´t overload above the MAX mark
on the kettle!